In terms of build quality, it's definitely not on par with my Mesa cabinet, but it's completely gig-worthy, sounds great, and doesn't look embarrassing. Overall: I've been delighted with this speaker cab so far. Since I bought it used, I don't imagine I'll be contacting their customer service. Service & Reliability: No problems with it so far. I suspect this saves time time as well as allowing them to get away with thinner ply. Like the Avatar cab of which it is a clone, its edges and corners are pretty square - not nearly as rounded as a Marshall or Mesa cab. The little rubber feet look decent if small, but it's irrelevant to me because I installed casters as soon as I decided to keep it. Tolex is well-applied, and the corners are black steel. The bracing is clean-looking and the cab feels sturdy. Everything except for the back panel is hardwood ply, including the speaker baffle. Paired with my Mesa 4x12, it makes a killer wall of sound.įeel, fit and finish: Build quality is surprisingly good for such an inexpensive cabinet. If I needed super tight palm mutes, I would at the very least put a new closed back panel on it, and might consider another cab entirely, but for my current purposes it sounds great. It has great projection and adds a certain Marshally nastiness to my sound that is quite welcome, probably due in part to the speakers. As you add gain, it roars on anything from Social Distortion to pre- Master of Puppets Metallica. Clean and semi-clean sounds are massive sounding and very three-dimensional. Loaded with Celestion T-75s and powered by my Mesa/Boogie Mark III, this speaker cabinet is pure rock. However, it took only a few minutes of tinkering to find a spot where my amp makes both cabs sound great at the same time. when running through my Mesa Recto 4x12). The first time I plugged into this cab, I almost immediately dialed the bass down from where it had been set before (i.e. Those qualities are exacerbated by the cab's 1/2" ply construction (thinner than Marshall, Mesa, Whitebox, etc.), and in the case of my particular model by its aftermarket sawn-off back panel. By comparison, a Marshall 1936 is 23.5" H x 29" W x 12" D and a Mesa Recto 2x12 is only 17.5" H x 30" W x 14.25" D - both over 20% smaller in volume.īecause of that, this cabinet has a huge low end that at its best is warm and room-filling, and at worst can run away from you a little bit. (The Avatar cab of which this is a copy is similarly oversized.) As soon as I bought this cabinet, I felt as though it was pretty large compared to 2x12 cabs I've owned before, but I didn't realize just how big until I started shopping for slip covers for it, and found out that covers for Mesa/Marshall/Bogner/etc. The first thing to know about this cab is that it is EEEEEEEENORMOUS for a 2x12 cab, and that size definitely factors into the sound. One nice thing is that I have tons of experience with the Marshall 1936, which is a 2x12 with the same speakers, so I can make some comparisons based on that. Sound: Since this is a review of a cabinet that is usually sold unloaded, I will do my best to review the sonic properties of the cab, not the speakers that happen to be in it. Mine is currently wired for 8 ohms mono, but since these are usually sold unloaded, they give you dual jacks so that you can wire it for mono, stereo, or parallel. for close studio miking.) This is a genius feature and I wish other companies would do it. It stays on securely, yet pulls off easily with the two attached pull tabs, (e.g.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |